Service Guidelines; Tools Required For Installation And Service - Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual

Service Guidelines

Be sure to keep the following guidelines in mind when servicing the system:
Except for removing and installing disk drives, the system must be serviced by
qualified service providers.
Only power supplies and disk drives are hot-pluggable. You must power off the
system to service any other component.
You must disconnect the AC power cords when servicing the following
components:
To prevent damaging the system doors while working inside the system, remove
the top cover, then close the system doors. Follow this guideline when servicing
the following components:
Tools Required for Installation and
Service
The following tools are required to install and service the system:
Screwdriver, Phillips No. 1
Screwdriver, Phillips No. 2
Screwdriver, long Phillips No. 2 (shaft at least 8 inches/120.32 cm long)
Adjustable wrench
Electrostatic discharge (ESD) mat, Sun part number 250-1088, or equivalent
Grounding wrist or foot strap
18 Sun Fire V440 Server Parts Installation and Removal Guide • July 2003
Motherboard
Keyswitch
SCSI backplane
Connector board
System configuration card (SCC) reader
Advanced Lights Out Manager (ALOM) system controller card
CPU/memory module
PCI card
ALOM card
PCI fan tray (Fan tray 0)
CPU fan tray (Fan tray 1)
Connector board
Cables