How To Remove The System Control Keyswitch Cable - Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual

3. Tuck the cable under the two metal tabs located on the chassis above power
supply 0.
4. Connect the AC power cords to the back of the system.
What Next
Complete these tasks:
"How to Install the Top Cover" on page 35
"How to Slide the System Into the Cabinet" on page 32
"How to Power On the System" on page 19
How to Remove the System Control
Keyswitch Cable
Before You Begin
Complete these tasks:
"How to Power Off the System" on page 23
"How to Slide the System Out of the Cabinet" on page 29
"How to Avoid Electrostatic Discharge" on page 44
"How to Remove the Top Cover" on page 34
What to Do
Caution – The system supplies power to the system control keyswitch cable even
when the system is powered off. To avoid personal injury or damage to the system,
you must disconnect the AC power cords before servicing the system control
keyswitch cable.
1. Disconnect the AC power cords from the back of the system.
142 Sun Fire V440 Server Parts Installation and Removal Guide • July 2003