How To Install The Connector Board - Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual

How to Install the Connector Board

Before You Begin
Complete this task:
"How to Remove the Connector Board" on page 126
What to Do
Caution – The system supplies power to the connector board even when the system
is powered off. To avoid personal injury or damage to the system, you must
disconnect the AC power cords before servicing the connector board.
1. Disconnect the AC power cords from the back of the system.
2. Place the connector board into the chassis.
Align the two front mounting posts with the holes in the connector board.
3. Slide the connector board toward the back of the system to connect the board to
the SCSI backplane.
The connector board clicks into place.
4. Secure the connector board to the chassis with the Phillips No. 2 captive screw.
128 Sun Fire V440 Server Parts Installation and Removal Guide • July 2003