Sun Microsystems Sun Fire V440 Parts Installation And Removal Manual page 108

2. If you are installing a PCI card into an unused slot, remove the corresponding
filler panel from the system back panel. Otherwise, go to Step 3.
a. Remove the Phillips No. 1 screw securing the PCI filler panel to the system
back panel.
b. Lift out the filler panel and save it for future use.
3. Insert the PCI card into the appropriate slot on the motherboard.
Make sure that the faceplate of the PCI card is not bent. A bent faceplate could affect
the installation of the card.
a. Insert the faceplate end of the card into the appropriate opening in the back
panel.
If you are installing a PCI long card, guide the opposite end of the PCI card into
the correct card guide on the PCI fan tray (fan tray 0).
b. Push the card into the corresponding connector on the motherboard.
Apply even pressure along each edge of the card.
Caution – Do not apply excessive force to one end or one side of the card. Doing so
could damage the card or the motherboard connector.
4. Secure the PCI card faceplate to the system back panel with the Phillips No. 1
screw.
96 Sun Fire V440 Server Parts Installation and Removal Guide • July 2003