Calibrating The Lcd - Quantum Data 780B User Manual

780B Video Generator/Analyzer – User Guide
HDMI OUT
3.4

Calibrating the LCD

It is recommended that you calibrate the LCD display prior to using the 780B Test Instrument. Use the following
procedures to perform the calibration.
December 1, 2014
3D Status
AVMute status
HDCP Status
+5V Status
Video Type
Status/Selection
Video Resolution
Status/Selection
Video Pattern
Status/Selection
3D Format
Status/Configuration
Audio Status
HDCP Status
AVMute
HDCP Status
+5V Status
Indicates the status of 3D video. This includes:
 3D enabled or disabled
3D format

Indicates the AVmute status, enabled or disabled.
Indicates whether the incoming video is encrypted
with HDCP.
Indicates whether +5V is detected from the source.
Indicates the video on the HDMI Tx port. This
includes:
 Video interface: HDMI or DVI
 Color depth: 8, 10, 12
Video type: RGB or YCbCr

Sampling mode: 4:4:4, 4:2:2, 4:2:0

Provides access to the Video Signal Type screen.
Indicates the video resolution on the HDMI Tx port.
This includes:
Horizontal Active in pixels

Vertical Active in pixels

Frame rate

Provides access to the Video Format screen.
Indicates the video pattern on the HDMI Tx port.
Provides access to the Video Pattern screen.
Indicates the status of 3D video. This includes:
 3D enabled or disabled
 3D format
Provides access to the 3D video configuration
screen.
Indicates the Audio status:
 Audio format
Audio channels

Audio sampling rate

Indicates whether the incoming video on the HDMI
In port is encrypted with HDCP.
Indicates the status of:
AVMute active/inactive status

HDCP active/inactive status

+5V present/not present status

Page 17
Revision A7