Snmp-Server Community Ipmask; Snmp-Server Community Mode - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
10.1.3.1 no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is
the applicable community name.
Format
Mode

10.1.4 snmp-server community ipmask

This command sets a client IP mask for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client IP
address value to denote a range of IP addresses from which SNMP clients may use that
community to access the device. A value of 255.255.255.255 will allow access from only
one station, and will use that machine's IP address for the client IP Address. A value of
0.0.0.0 will allow access from any IP address. The name is the applicable community
name.
Default
Format
Mode
10.1.4.1 no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is the
applicable community name. The community name may be up to 16 alphanumeric
characters.
Format
Mode

10.1.5 snmp-server community mode

This command activates an SNMP community. If a community is enabled, an SNMP
manager associated with this community manages the switch according to its access right.
If the community is disabled, no SNMP requests using this community are accepted. In
this case the SNMP manager associated with this community cannot manage the switch
until the Status is changed back to Enable.
Default
Format
Mode
SNMP Commands
no snmp-server community ipaddr <name>
Global Config
0.0.0.0
snmp-server community ipmask <ipmask> <name>
Global Config
no snmp-server community ipmask <name>
Global Config
private and public communities - enabled; other four - dis-
abled
snmp-server community mode <name>
Global Config
v1.0, November 2007
10-3