Spanning-Tree Configuration Revision; Spanning-Tree Edgeport; Spanning-Tree Forceversion - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-

5.1.4 spanning-tree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision
Level is a number in the range of 0 to 65535.
Default
Format
Mode
5.1.4.1 no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value, i.e. 0.
Format
Mode

5.1.5 spanning-tree edgeport

This command specifies that this port is an Edge Port within the common and internal
spanning tree. This allows this port to transition to Forwarding State without delay.
Format
Mode
5.1.5.1 no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
Mode

5.1.6 spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force
Protocol Version can be one of the following:
• 802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d
functionality supported)
• 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w
functionality supported)
Spanning Tree Protocol Commands
0
spanning-tree configuration revision <0-65535>
Global Config
no spanning-tree configuration revision
Global Config
spanning-tree edgeport
Interface Config
no spanning-tree edgeport
Interface Config
v1.0, March 2006
5-3