Adding An Annotation - Keysight Technologies InfiniiVision 2000 X Series User Manual

20
Utility Settings
To configure the [Quick Action] key:
1 Press [Utility] > Quick Action > Action; then, select the action that should be
Once the [Quick Action] key is configured, you simply press it to perform the
selected action.

Adding an Annotation

You can add an annotation to the upper left corner of the oscilloscope's display.
The annotation is useful for documentation purposes, to add notes before
capturing screens.
To add an annotation:
1 On the oscilloscope's front panel, press [Utility].
2 In the Utility Menu, press Annotation.
292
performed:
• Off — disables the [Quick Action] key.
• Quick Measure All — displays a popup containing a snapshot of all the single
waveform measurements. The Source softkey lets you select the waveform
source (which also becomes the source selection in the Measurement
Menu). See Chapter
• Quick Print — prints the current screen image. Press Settings to set up the
printing options. See
• Quick Save — saves the current image, waveform data, or setup. Press Settings
to set up the save options. See
Data)," starting on page 257.
• Quick Recall — recalls a setup, mask, or reference waveform. Press Settings to
set up the recall options. See
Data)," starting on page 257.
• Quick Freeze Display — freezes the display without stopping running
acquisitions or un-freezes the display if currently frozen. For more
information, see "To freeze the display"
• Quick Trigger Mode — toggles the trigger mode between Auto and Normal, see
"To select the Auto or Normal trigger mode"
• Quick Clear Display — clears the display, see
page 128.
14, "Measurements," starting on page 203.
Chapter 19, "Print (Screens)," starting on page 269.
Chapter 18, "Save/Recall (Setups, Screens,
Chapter 18, "Save/Recall (Setups, Screens,
on page 129.
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
on page 170.
"To clear the display" on