Install The Optional Lan/Vga Or Gpib Module; Tilt The Oscilloscope For Easy Viewing - Keysight Technologies InfiniiVision 2000 X Series User Manual

1
Getting Started

Install the Optional LAN/VGA or GPIB Module

If you need to install a DSOXLAN LAN/VGA module or a DSOXGPIB GPIB module,
perform this installation before you power on the oscilloscope.
1 If you need to remove a module before installing a different module, pinch the
2 To install a module, slide the module into the slot on the back until it is fully
The LAN/VGA or GPIB module must be installed before powering on the oscilloscope.
NOTE

Tilt the Oscilloscope for Easy Viewing

There are tabs under the oscilloscope's front feet that can be flipped out to tilt the
oscilloscope.
26
module's spring tabs, and gently remove the module from the slot.
seated.
The module's spring tabs will latch into the slot, keeping the module in place.
WARNING: MAIN TAIN
GROUND TO AVOID
ELECTRIC SHOCK
~ 100-120V, 50/60/400Hz
~ 100-240V, 50/60Hz
100 Watts MAX
LAN/VGA Module
Module Slot
GPIB Module
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide