Front Panel Overlays For Different Languages - Keysight Technologies InfiniiVision 2000 X Series User Manual

18. Demo 2, Ground, and
Demo 1 terminals
19. USB Host port
20. Digital channel
inputs
21. Waveform generator
output

Front Panel Overlays for Different Languages

Front panel overlays, which have translations for the English front panel keys and
label text, are available in 10 languages. The appropriate overlay is included when
the localization option is chosen at time of purchase.
To install a front panel overlay:
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
• Demo 2 terminal — This terminal outputs the Probe Comp signal which helps you match a
probe's input capacitance to the oscilloscope channel to which it is connected. See
"Compensate Passive Probes"
oscilloscope can also output demo or training signals on this terminal.
• Ground terminal — Use the ground terminal for oscilloscope probes connected to the Demo
1 or Demo 2 terminals.
• Demo 1 terminal — With certain licensed features, the oscilloscope can output demo or
training signals on this terminal.
This port is for connecting USB mass storage devices or printers to the oscilloscope.
Connect a USB compliant mass storage device (flash drive, disk drive, etc.) to save or recall
oscilloscope setup files and reference waveforms or to save data and screen images. See
Chapter 18, "Save/Recall (Setups, Screens, Data)," starting on page 257.
To print, connect a USB compliant printer. For more information about printing see
Chapter 19, "Print (Screens)," starting on page 269.
You can also use the USB port to update the oscilloscope's system software when updates are
available.
You do not need to take special precautions before removing the USB mass storage device
from the oscilloscope (you do not need to "eject" it). Simply unplug the USB mass storage
device from the oscilloscope when the file operation is complete.
CAUTION: Do not connect a host computer to the oscilloscope's USB host port. Use the
device port. A host computer sees the oscilloscope as a device, so connect the host computer
to the oscilloscope's device port (on the rear panel). See
page 275.
There is a second USB host port on the back panel.
Connect the digital probe cable to this connector (MSO models only). See
Channels," starting on page 101.
Outputs sine, square, ramp, pulse, DC, or noise on the Gen Out BNC. Press the [Wave Gen] key
to set up the waveform generator. See
245.
on page 32. With certain licensed features, the
"I/O Interface Settings"
Chapter 17, "Waveform Generator," starting on page
1
Getting Started
on
Chapter 6, "Digital
39