Adding 86100D Or N1000A To Keysight Connection Expert - Keysight Technologies N1091 CA Series Getting Started

3 Installing N1091..CA on a PC Without N1010A FlexDCA

Adding 86100D or N1000A to Keysight Connection Expert

Most of the measurements in the IEEE 802.3 NRZ Test Application use a supported DCA-X or DCA-M
sampling oscilloscope.
N OTE
Note that the Keysight I/O Library Suite must be installed before you proceed with connecting to the
network analyzer. The user interface for Keysight Connection Expert 2017 (Version 18.0) and higher
is slightly different from its previous versions, such as Version 17.2 or earlier.
Connection using Keysight Connection Expert v17.2 (or earlier)
1
2
3
Figure 66
4
66
This section lists the steps for 86100D DCA-X oscilloscope. Perform similar steps for the
N1000A DCA-X oscilloscope.
On the 86100D Oscilloscope, launch the Keysight FlexDCA application.
From the FlexDCA's main menu, click Help > About FlexDCA.... The About 86100D dialog box
appears.
In the System Information area, scroll down to view the Computer Name entry.
Alternatively, you can obtain the computer name from the Windows System properties.
86100D Oscilloscope's hostname
Record the Computer Name (corresponds to hostname) as you will need this name later in this
procedure.
IEEE 802.3 NRZ Compliance Test Application Getting Started