Use Only The Power Cord That Came With The Oscilloscope; Connect Probes To The Oscilloscope - Keysight Technologies InfiniiVision 2000 X Series User Manual

1
Getting Started
When using the oscilloscope in a bench-top setting, provide at least 2" clearance
at the sides and 4" (100 mm) clearance above and behind the oscilloscope for
proper cooling.
To power-on the
oscilloscope
CAUTION
The power cord provided is matched to the country of origin of the order.
1 Connect the power cord to the rear of the oscilloscope, then to a suitable AC
2 The oscilloscope automatically adjusts for input line voltages in the range 100
Always use a grounded power cord. Do not defeat the power cord ground.
WARNING
3 Press the power switch.
The power switch is located on the lower left corner of the front panel. The
oscilloscope will perform a self-test and will be operational in a few seconds.

Connect Probes to the Oscilloscope

1 Connect the oscilloscope probe to an oscilloscope channel BNC connector.
28

Use only the power cord that came with the oscilloscope

voltage source. Route the power cord so the oscilloscope's feet and legs do not
pinch the cord.
Install the instrument so that the detachable power cord is readily identifiable
and is easily reached by the operator. The detachable power cord is the
instrument disconnecting device. It disconnects the mains circuits from the
mains supply before other parts of the instrument. The front panel switch is only
a standby switch and is not a LINE switch. Alternatively, an externally installed
switch or circuit breaker (which is readily identifiable and is easily reached by
the operator) may be used as a disconnecting device.
to 240 VAC. The line cord provided is matched to the country of origin.
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide