Searching for CAN Data in the Lister
The oscilloscope's search capability lets you search for (and mark) certain types of
CAN data in the Lister. You can use the [Navigate] key and controls to navigate
through the marked rows.
1 With CAN selected as the serial decode mode, press [Search].
2 In the Search Menu, press the Search softkey; then, turn the Entry knob to select
3 Press Search; then, select from these options:
For more information on searching data, see
For more information on using the [Navigate] key and controls, see
Time Base"
Setup for LIN Signals
LIN (Local Interconnect Network) signal setup consists of connecting the
oscilloscope to a serial LIN signal, specifying the signal source, threshold voltage
level, baud rate, sample point, and other LIN signal parameters.
To set up the oscilloscope to capture LIN signals:
1 Press [Label] to turn on labels.
2 Press [Serial].
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
the serial slot (Serial 1 or Serial 2) on which the CAN signal is being decoded.
•
Remote Frame ID (RTR) — Finds remote frames with the specified ID. Press the
Bits softkey to enter the ID.
•
Data Frame ID (~RTR) — Finds data frames matching the specified ID. Press the
Bits softkey to enter the ID.
•
Remote or Data Frame ID — Finds remote or data frames matching the specified
ID. Press the Bits softkey to select the ID.
•
Data Frame ID and Data — Finds data frames matching the specified ID and
data. Press the Bits softkey to set the ID length, ID value, number of data
bytes, and data value.
•
Error Frame — Finds CAN active error frames.
•
All Errors — Finds any form error or active error.
•
Overload Frame — Finds CAN overload frames.
on page 57.
CAN/LIN Triggering and Serial Decode
"Searching Lister Data"
23
on page 122.
"Navigating the
335