Setup For Can Signals - Keysight Technologies InfiniiVision 2000 X Series User Manual

Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
23 CAN/LIN Triggering and
Serial Decode

Setup for CAN Signals / 327

CAN Triggering / 329
CAN Serial Decode / 331
Setup for LIN Signals / 335
LIN Triggering / 337
LIN Serial Decode / 338
The CAN/LIN triggering and serial decode option is license-enabled.
Setup for CAN Signals
Setup consists of connecting the oscilloscope to a CAN signal, using the Signals
Menu to specify the signal source, threshold voltage level, baud rate, and sample
point.
To set up the oscilloscope to capture CAN signals, use the Signals softkey which
appears in the Serial Decode Menu:
1 Press [Label] to turn on labels.
2 Press [Serial].
3 Press the Mode softkey; then, select CAN trigger type.
4 Press the Signals softkey to open the CAN Signals Menu.
327