Waveform Generator; To Output The Waveform Generator Sync Pulse; To Specify The Expected Output Load - Keysight Technologies InfiniiVision 2000 X Series User Manual

17

Waveform Generator

The Settings softkey opens the Waveform Generator Settings Menu which lets you
make other settings related to the waveform generator.
See:
•
•
•
•

To output the waveform generator sync pulse

1 If the Waveform Generator Menu is not currently displayed on the
2 In the Waveform Generator Menu, press the Settings softkey.
3 In the Waveform Generator Settings Menu, press the Trig Out softkey and turn
Waveform Type
All waveforms except
DC and Noise
DC
Noise

To specify the expected output load

1 If the Waveform Generator Menu is not currently displayed on the
2 In the Waveform Generator Menu, press the Settings softkey.
248

"To output the waveform generator sync pulse"

"To specify the expected output load"

"To use waveform generator logic presets"
"To restore waveform generator defaults"
oscilloscope's softkeys, press the [Wave Gen] key.
the Entry knob to select Waveform Generator Sync Pulse.
Sync Signal Characteristics
The Sync signal is a TTL positive pulse that occurs when the waveform
rises above zero volts (or the DC offset value).
N/A
N/A
oscilloscope's softkeys, press the [Wave Gen] key.
on page 248
on page 249
on page 255
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
on page 248