To Establish A Lan Connection - Keysight Technologies InfiniiVision 2000 X Series User Manual

When you connect the oscilloscope to a LAN it is a good practice to limit access to the
NOTE
oscilloscope by setting a password. By default, the oscilloscope is not password protected.
See
Any time you modify the oscilloscope's hostname, it breaks the connection between the
NOTE
oscilloscope and the LAN. You need to re-establish communication to the oscilloscope using
the new hostname.

To establish a LAN connection

Automatic 1 Press [Utility] > I/O.
Configuration
2 Press the LAN Settings softkey.
3 Press the Config softkey; then, turn the Entry knob to select Automatic, and press
4 If your network provides Dynamic DNS, you can enable the Dynamic DNS option
5 You can enable the Multicast DNS option to let the oscilloscope use Multicast
6 Connect the oscilloscope to the local area network (LAN) by inserting the LAN
Manual 1 Get the oscilloscope's network parameters (host name, IP address, subnet
Configuration
2 Press [Utility] > I/O.
3 Press the LAN Settings softkey.
4 Press the Config softkey; then, turn the Entry knob to select Automatic, and press
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
"Setting a Password"
the softkey again to enable it.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
to let the oscilloscope register its hostname and use the DNS server for name
resolution.
DNS for name resolution on small networks without a conventional DNS server.
cable into the "LAN" port on the rear panel of the oscilloscope.
In a few moments the oscilloscope will connect to the network automatically.
If the oscilloscope does not automatically connect to the network, press [Utility]
> I/O > LAN Reset. In a few moments the oscilloscope will connect to the
network.
mask, gateway IP, DNS IP, etc.) from your network administrator.
the softkey again to disable it.
on page 305 to set a password.
20
Utility Settings
277