Measurements Summary - Keysight Technologies InfiniiVision 2000 X Series User Manual

14
Measurements

Measurements Summary

The automatic measurements provided by the oscilloscope are listed in the
following table. All measurements are available for analog channel waveforms. All
measurements except Counter are available for math waveforms other than FFT. A
limited set of measurements is available for math FFT waveforms and for digital
channel waveforms (as described in the following table).
Measurement
"Snapshot All"
"Amplitude"
"Average"
"Base"
"Bit Rate"
"Delay"
"Duty Cycle"
"Fall Time"
"Frequency"
"Maximum"
"Minimum"
"Rising Edge Count"
page 223
"Falling Edges Count"
page 223
"Positive Pulse Count"
page 222
206
Valid
for
Math
FFT
on page 207
on page 209
on page 212 Yes, Full
Screen
on page 210
on page 217
on page 218
on page 218
on page 218
on page 216
on page 209 Yes
on page 209 Yes
on
on
on
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
Valid for Notes
Digital
Channels
*
Yes
Measures between two sources.
Press Settings to specify the second
source.
Yes
Yes