•
•
•
•
•
•
•
•
•
Peak-Peak
The peak-to-peak value is the difference between Maximum and Minimum values.
The Y cursors show the values being measured.
Maximum
Maximum is the highest value in the waveform display. The Y cursor shows the
value being measured.
Minimum
Minimum is the lowest value in the waveform display. The Y cursor shows the
value being measured.
Amplitude
The Amplitude of a waveform is the difference between its Top and Base values.
The Y cursors show the values being measured.
Top
The Top of a waveform is the mode (most common value) of the upper part of the
waveform, or if the mode is not well defined, the top is the same as Maximum. The
Y cursor shows the value being measured.
See Also
•
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
"Minimum"
on page 209
"Amplitude"
on page 209
"Top"
on page 209
"Base"
on page 210
"Overshoot"
on page 210
"Preshoot"
on page 212
"Average"
on page 212
"DC RMS"
on page 213
"AC RMS"
on page 213
"To isolate a pulse for Top measurement"
Measurements
on page 210
14
209