Setting Oscilloscope Preferences; To Choose "Expand About" Center Or Ground - Keysight Technologies InfiniiVision 2000 X Series User Manual

You do not need to "eject" the USB mass storage device before removing it. Simply
ensure that any file operation you've initiated is done, and remove the USB drive
from the oscilloscope's host port.
Do not connect USB devices that identify themselves as hardware type "CD"
because these devices are not compatible with the InfiniiVision X-Series
oscilloscopes.
If two USB mass storage devices are connected to the oscilloscope, the first one is
designated "\usb" and the second one is designated "\usb2".
See Also •

Setting Oscilloscope Preferences

The User Preferences Menu (under [Utility] > Options > Preferences) lets you specify
oscilloscope preferences.
•
•
•
•
•

To choose "expand about" center or ground

When you change a channel's volts/division setting, the waveform display can be
set to expand (or compress) about the signal ground level or the center of the
display.
To set the waveform expansion reference point:
1 Press [Utility] > Options > Preferences > Expand and select:
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
Chapter 18, "Save/Recall (Setups, Screens, Data)," starting on page 257
"To choose "expand about" center or ground"
"To disable/enable transparent backgrounds"
"To load the default label library"
"To set up the screen saver"
"To set AutoScale preferences"
• Ground— The displayed waveform will expand about the position of the
channel's ground. This is the default setting.
The ground level of the signal is identified by the position of the ground level
( ) icon at the far-left side of the display.
The ground level will not move when you adjust the vertical sensitivity
(volts/division) control.
on page 281
on page 282
on page 282
on page 282
on page 283
20
Utility Settings
281