Inter-Tel AXXESS Administrator's Manual page 85

Red and Green LEDs
Newer Inter-Tel Executive, Standard and Basic Digital Keysets have red and green LEDs in the
key lamps. When both colors are used, a green lamp generally indicates that the call is active,
ringing, or holding at your station (see below for a possible exception for direct ring-in calls).
When the lamp is red, the call is active, ringing, or holding at another station. Trunk access,
allowed-answer permission, and the feature being used (for example, System Hold or Call
Transfer) determine whether you can pick up a (red) call from another station.
There are two system-wide programming options that controls these LEDs.
•
•
Connecting A Headset
For convenience, an electret headset can be used at any keyset station. The SPKR key is used
to connect and disconnect calls when the headset is attached.
Some headsets have a power-saver mode that disables the headphone after a period of silence.
To prevent these headsets from missing portions of incoming calls, there is a station flag called
"Headset Connect Tone." Enabling this flag allows the keyset to generate a tone that activates
the headset before connecting to an incoming call. In the default state, it is disabled.
T
O CONNECT A HEADSET
(1)
(2)
(3)
T
O DISCONNECT THE HEADSET
(1)
(2)
(3)
Station Instruments
INTER-TEL AXXESS ADMINISTRATOR'S GUIDE – Issue 5.1, March 2000
Allow Green LEDs: This flag gives the installer the option of having all red/green key-
sets and red-only keysets operate the same, or allowing the red/green keysets to use the
green LEDs. If this flag is enabled, the dual-color keysets will use both the red and
green LEDs. If it is disabled, the keysets will operate in red-only mode, like the keysets
without green LEDs. In the default state, the flag is disabled.
Use Green LEDs For Direct Ring: This flag determines whether direct ring-in calls
cause a red or green lamp. If the flag is enabled, direct ring-in calls to your station will
be green. If disabled, all direct ring-in calls will cause the LED to be red. In the default
state, this flag is enabled.
NOTE
The Allow Green LEDs flag must be enabled in order for this flag to operate.
:
Disconnect the handset by unplugging the coiled handset cord from the base of the key-
set. Leave the handset in the cradle.
Insert the headset plug into the vacant handset jack.
While on hook, enter the Headset On feature code (315) or the Headset On/Off feature
code (317). The display shows HEADSET MODE ON.
:
Disconnect the headset by unplugging the headset cord from the base of the keyset.
Plug the coiled handset cord into the base of the keyset.
While on hook, enter the Headset Off feature code (316) or the Headset On/Off feature
code (317). The display shows HEADSET MODE OFF.
AXXESS System Hardware
Page 65