Remote Feature Programming; Station Password - Inter-Tel AXXESS Administrator's Manual

REMOTE FEATURE PROGRAMMING

The Remote Programming feature allows a user to place a phone in do-not-disturb mode
(DND) or forward the station's calls, either from another station or through DISA. Each station
has a password to limit access to this feature. (See
In a network, Remote Programming can be performed on one node for any keyset that is pro-
grammed as an off-node device on that node. You must go through DISA for remote program-
ming of any keysets that are not programmed as off-node devices.

STATION PASSWORD

The station password is used only for the Remote Programming feature.
NOTE
gramming should have a password. To make the passwords difficult to guess, they should not
match the extension number or consist of one digit repeated several times.
The station password can be up to 8 digits in length. The default password is the extension
number of the station. The password can be changed by entering the Program Station Password
feature code at the station or when using the Remote Programming feature. It can also be pro-
grammed through Individual Station programming.
If the password is changed from a station, the user will be prompted for the old password, then
the new password, and will be asked to verify the new password. If it is programmed through
Remote Programming, the user will already have entered a correct password, so the user is
only prompted for the new password and will be asked to verify the password.
Should the verified password and new password not match, the old password will be retained
and the programming session canceled.
T
O CHANGE THE STATION PASSWORD FROM YOUR STATION
(1)
(2)
(3)
(4)
Remote Feature Programming
INTER-TEL AXXESS ADMINISTRATOR'S GUIDE – Issue 5.1, March 2000
To prevent unauthorized use of the call forward feature, all stations using Remote Pro-
Enter the Program Station Password feature code (392). You hear a confirmation tone.
If you have a display, it shows ENTER PASSWORD.
Enter your current password, followed by #. (At default it is your extension number.) If
you have a display, it shows NEW PASSWORD.
NOTE
If you enter an incorrect password, the display will show INVALID PASS-
WORD and your station will return to the idle state.
Enter the new password followed by #. You hear a confirmation tone.
Enter the new password again for verification followed by #. You hear a confirmation
tone. If you have a display, it shows PASSWORD SAVED. Your station returns to the
idle state.
AXXESS System Features
page 111 for information about DISA.)
:
Page 193