Remote Forward Programming - Inter-Tel AXXESS Administrator's Manual

AXXESS System Features
INTER-TEL AXXESS ADMINISTRATOR'S GUIDE – Issue 5.1, March 2000

REMOTE FORWARD PROGRAMMING

T
O FORWARD A STATION USING THE REMOTE PROGRAMMING FEATURE
NOTE
using a DISA line will hear confirmation tone followed by DISA dial tone. Display keyset
users will not hear confirmation tones but will see a prompt asking for the next entry.
(1)
(2)
(3)
(4)
(5)
(6)
Page 196
After each entry, non-display keyset users will hear a confirmation tone. Outside callers
If calling from an outside telephone, access the system through a DISA line. Enter the
DISA security code (if applicable). You hear a confirmation tone followed by DISA
dial tone.
If programming from another station, lift the handset or press the SPKR key.
Enter the Remote Programming feature code (359). If you have a display, it shows
ENTER EXTENSION. (Executive Keyset users can press the IC DIR key to use the
intercom directory to look up a number.)
Enter the extension to be forwarded. If you have a display, it shows ENTER PASS-
WORD. If you entered an invalid extension number, you will hear reorder tones and can
try again.
Enter the extension's password, followed by #. If you have a display, it shows ENTER
FEATURE CODE.
NOTE
If you enter an incorrect password, the display will show INVALID PASS-
WORD and the call is disconnected. Station users will hear reorder tones.
To turn on Call Forward:
a. Enter one of the following Call Forward feature codes. If you entered an invalid
feature code, you will hear reorder tones and can try again.
Call Forward All Calls355
Call Forward If Busy 357
Call Forward If No Answer356
Call Forward If No Answer/Busy358
b. Enter the forwarding destination. This can be an extension number or a trunk
access code followed by an outside telephone number.
If the forward destination is an extension number, programming is complete and the
call is disconnected automatically.
If the forward destination is an outside number, hang up to complete the program-
ming.
If the station is not permitted to forward to the destination entered, you will hear
reorder tones and can try again.
If you hang up before entering a forward destination, the programmed forward is
canceled.
To turn off Call Forward: Enter 355 and then hang up instead of entering a destina-
tion.
:
Remote Forward Programming