Table of Contents
Advertisement
Using the Configuration Pages
There are three Configuration pages, which only administrators can access. When you
click the
screen. The following sections describe the changes you can make from these pages.
System Settings Page
On the System Settings page (figure 34), you can set IP parameters for the WindoWall Pro.
Figure 34.
To change your system settings:
1.
2.
3.
IP Settings fields
The IP Settings fields provide a location for viewing and editing settings unique to the
Ethernet interface. After editing any of the settings on this page, click the
the bottom of the IP Settings panel.
Unit Name field
The
the factory consists of the model name, followed by the last three character pairs of the
MAC
characters.
NOTE: The following characters are invalid in the name:
tab, these pages are listed on the sidebar menu at the left of the
Configuration
System Settings Page
On the
tab, select
Configuration
edge of the screen.
Select or enter the new information in the desired fields.
When you have made all the desired inputs, click the
the panel. The new settings appear in the fields.
field contains the name of the WindoWall Pro. The name assigned at
Unit Name
address. You can change this name field to any valid name, up to 24 alphanumeric
+ ~ , @ = ` [ ] { } < > ' " ; : | \
WindoWall Pro Series • HTML Configuration and Control
from the sidebar menu at the left
System Settings
button at the bottom of
Submit
and
?.
button at
Submit
54
Advertisement
Table of Contents
