Maintenance And Inspection Precautions; Labels; Stp Pump Installation Warning Label; Hot Surface Warning Label - Edwards STP-iS2207 Series Instruction Manual

1.5

Maintenance and inspection precautions

1
Perform any maintenance or inspection of the STP pump under the condition that no power is
applied to the STP pump (refer to SEMI S2 Section 13.2 - type 1), following Section 8,
"MAINTENANCE AND INSPECTION".
1.6

Labels

The following labels are affixed to the STP pump. Read the contents of the labels before operation.
1.

STP pump installation warning label

This label describes installation of the STP pump. Install the STP pump according to the
precautions. Install the STP pump according to the precautions of Section 3, "INSTALLATION
OF THE STP PUMP".
2.

Hot surface warning label

This label instructs operators so as not to touch the hot surface of the baking heater.
The baking heater may lead to a considerable rise in temperatures outside of the STP pump.
(only with baking heater)
MT-89E-001-C
Page 6
STP-iS2207 Series Turbomolecular Pump
Figure 1 - STP pump installation warning label
Figure 2 - Hot surface warning label