Query Command; (In The Rs232/Rs485 Single Point Connection) - Edwards STP-iS2207 Series Instruction Manual

Then the preceding SIM->PC character is "Ack", the instructed control command is executed and the
SIM returns the following response.
5
PC->SIM
SIM->PC Stx
The PC transmits "Ack" or "Nak"; then transmits the next command if necessary.
Transmission frame when data is transmitted to two blocks (message is more than 256 characters
and less than 512 characters):
Designate the control command (the 1st block) on the PC
PC->SIM Stx
SIM->PC
Next, the preceding SIM->PC character is "Ack", the PC continues instructing the control command
(the 2nd block).
PC->SIM Stx
SIM->PC
Always assign less than 510 characters (n< 510) to the parameter so that the message is less than
512 characters.
Then the preceding SIM->PC character is "Ack", the instructed control command is executed and the
SIM returns the following response.
PC->SIM
SIM->PC Stx
The PC transmits "Ack" or "Nak"; then transmits the next command if necessary.
5.3.4 Query command (in the RS232/RS485 single point connection)
A query command is used to read the pump operation state and setting values. The first character of
the query command in the RS232/RS485 single point connection is "?"(HEX code "3F"), and
succeeding characters are ASCII characters corresponding to the respective function code and
parameter.
? CHR
CHR: Function code character, C
MT-89E-001-C
Page 80
STP-iS2207 Series Turbomolecular Pump
0 0 1 # or !
0 0 1 Sp CHR C
0 0 2 C
254
0 0 1 # or !
C C
1 2
to C : Parameter
1 n
Ack or Nak
Etx LRC
C Etb LRC
1 253
C Etx LRC
n
Ack or Nak
Ack or Nak
Etx LRC
C
n
Ack or Nak