Attaching A Baking Heater - Edwards STP-iS2207 Series Instruction Manual

3.8

Attaching a baking heater

The surfaces of the STP pump and its peripheral equipment will become extremely
hot when performing baking. NEVER touch them with bare hands.
DO NOT apply excessive force to the cable for the baking heater.
Wind the baking heater around the surface of the STP pump tightly. If the baking heater is not
The baking heater is not included in the scope of supply.
When preparing the baking heater at your company, refer to the external appearance on each
Instruction Manual of the STP pump before purchasing it.
Install the baking heater near the inlet port flange in the perimeter of the envelope. (see Figure 28)
STP-iS2207 Series Turbomolecular Pump
WARNING
CAUTION
CAUTION
wound tightly, the loose parts will overheat.
Baking heater
Figure 28 - Baking heater installation position
Hot surface warning label
MT-89E-001-C
Page 47
3