Cleaning And Care; Maintenance; Legal Information - Otto Bock 8E38 8 Series Instructions For Use Manual

Beep signal
2 x short
3 x short
7 Storage
If the System Electric Hand will not be used, store the System Electric Hand in the open position
to protect the sensors and mechanism.

8 Cleaning and Care

1) Clean the product with a damp cloth and mild soap (e.g. Ottobock 453H10=1-N Derma
Clean) when needed.
Ensure that no liquid penetrates into the system component(s).
2) Dry the product with a lint-free cloth and allow it to air dry fully.
INFORMATION
Avoid exposing the product without a prosthetic glove to direct sunlight or UV light (solarium) for
extended periods.
Please see the information included with the glove for prosthetic glove care instructions. Further
information is available from your O&P professional.

9 Maintenance

Performing regular maintenance (service inspections) every 24 months is recommended to pre­
vent injuries and maintain the quality of the product.
In general, all products are subject to compliance with the maintenance intervals during the war­
ranty period. This is the only way to maintain full warranty cover.
Additional services such as repairs may be provided in the course of maintenance. These addi­
tional services may be provided free of charge or can be billable according to an advance cost
estimate, depending on the extent and validity of the warranty.

10 Legal information

10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.
10.2 Trademarks
All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
10.3 CE conformity
Otto Bock Healthcare Products GmbH hereby declares that the product is in compliance with
applicable European requirements for medical devices.
Additional display
LED on charging
receptacle lights up
briefly
-
Event
Switch on prosthesis
Battery voltage too low, prosthesis shuts off auto­
matically
45