Cleaning And Care; Maintenance; Legal Information - Otto Bock DynamicArm Plus Instructions For Use Manual

Hide thumbs Also See for DynamicArm Plus:
Table of Contents

Advertisement

Available languages

Available languages

Cleaning and Care

7.3.2.15 MyoGraph
7.3.2.16 Loading and saving programs
Load program
User-defined programs can be loaded after clicking the "OPEN" button.
Save program
After clicking the "SAVE" button, user-defined programs can be saved to the hard drive under a freely defined
name.
Default program
After clicking the "Default Program" button, all patient-specific settings are reset to the default settings. Settings
that were not saved are erased.
INFORMATION
The maximum lifting speed has been reduced on delivery. Clicking the "Default Program" button sets the maxim­
um lifting speed. Select this button before configuring patient-specific settings.
8 Cleaning and Care
NOTICE
Improper product care
Damage to the product due to the use of incorrect cleaning agents.
► Only clean the product with a damp cloth and mild soap (e.g. 453H10=1-N Ottobock DermaClean).
1) Clean the product with a damp cloth and mild soap (e.g. 453H10=1-N Ottobock Derma Clean) when needed.
Make sure that no liquids get into the product and product components.
2) Dry the product with a lint-free cloth and allow it to air dry fully.

9 Maintenance

Regular maintenance (service inspections) every 24 months is mandatory in the interest of patient safety, in order to
maintain operating reliability, to protect the extended warranty and to maintain basic safety.
The grace period is no more than one month before or three months after maintenance is due.
Additional services such as repairs may be provided in the course of maintenance. These additional services may
be provided free of charge or can be billable according to an advance cost estimate, depending on the extent and
validity of the warranty.
The following components must always be sent in for maintenance and repairs:
The product, battery charger and power supply. The shipping container for the loaner unit you receive must be
reused for sending back the components requiring inspection.

10 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
10.2 Trademarks
All product names mentioned in this document are subject without restriction to the respective applicable trade­
mark laws and are the property of the respective owners.
66
All six control signals can be displayed. The scale range is divided into percent­
ages.
A 100% signal in the MyoGraph corresponds to the maximum voltage that can
be produced by the electrodes.
The vertical subdivision corresponds to one second.
DynamicArm Plus 12K110N=*

Advertisement

Table of Contents
loading

Table of Contents