Introduction To Parameters; Explanation Of List Of Parameters - Siemens CU240B-2 Parameter Manual

Parameters

Introduction to Parameters

1.1 Introduction to Parameters
1.1.1

Explanation of list of parameters

The layout of the parameter description is as follows (example only).
r0068[0...1]
Fig. 1-1
p0700[0...n]
CU240E-2
CU240E-2 F
CU/PM variants
Fig. 1-2
Parameter number
Indicates the relevant parameter number. The numbers used are 4 to 5-digit num-
bers. Numbers prefixed with an "r" indicate that the parameter is a "read-only"
parameter, which displays a particular value but cannot be changed directly by
specifying a different value via this parameter number.
All other parameters are prefixed with a "p". The values of these parameters can
be changed directly in the range indicated by the "Min" and "Max" settings in the
header. If these values have a physical unit, it is shown in brackets.
[index] indicates that the parameter is an indexed parameter and specifies the
range of indices available.
.0...15 indicates that the parameter has several bits, which can be evaluated or
connected individually.
CU/PM variants
Indicates for which Control Units and/or Power Modules the parameter is valid. If
no CUs or PMs are listed the parameter is valid for all variants.
1-8
Index BICO (if available)
CO: Absolute current actual value / I_act abs val
Access level: 3
Can be changed: -
Unit group: 6_2
Min
- [Arms]
Read-only parameter
Index BICO (if available)
Command source selection / Cmd src sel
Access level: 1
Can be changed: T
Unit group:-
Min
0
Write parameter
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: - Data type: FloatingPoint32
Scaling: p2002 Data set: -
Unit selection: p0505
Max Factory setting
- [Arms] - [Arms]
Calculated: - Data type: Integer16
Scaling: - Data set: CDS, p0170
Unit selection: -
Max Factory setting
184 0
© Siemens AG 2011 All Rights Reserved