Siemens CU240B-2 Parameter Manual page 333

p8999 USB functionality / USB functionality
Access level: 4
Can be changed: T
Units group: -
Min
1
Description: Selecting the USB functionality.
Value: 1:
2:
3:
Note: COMM: Commissioning.
A change only becomes effective after a POWER ON.
The parameter is not influenced by setting the factory setting.
p9301 SI Motion enable safety functions (processor 2) / SI Mtn enable P2
PM240 Access level: 3
PM250
Can be changed: C(95)
PM260
Units group: -
CU240E-2 DP F
Min
-
Description: Sets the enable signals for the safe motion monitoring.
Bit field: Bit Signal name
00 Enable SLS
16 Enable SSM hysteresis and filtering
17 Enable SDI
30 Enable F-DI in PROFIsafe telegram 900
Dependency: Refer to: p9501
Refer to: F01682, F01683
Notice: This parameter is overwritten by the copy function of the safety functions integrated in the drive.
Note: For bit 30 = 1, PROFIsafe telegram 900 must be configured in the F host.
A change only becomes effective after a POWER ON.
F-DI: Failsafe Digital Input
SDI: Safe Direction (safe motion direction)
SLS: Safely-Limited Speed
SSM: Safe Speed Monitor (safety-relevant feedback signal from the velocity monitoring)
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
USS commissioning via the virtual COM port
Only memory access
USB commissioning and memory access
Calculated: -
Scaling: -
Unit selection: -
Max
3
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Enable
Enable
Enable
Enable
Parameters
List of Parameters
Data type: Integer16
Data set: -
Factory setting
3
Data type: Unsigned32
Data set: -
Factory setting
0000 0000 0000 0000 0000 0000
0000 0000 bin
0 signal
Inhibit
Inhibit
Inhibit
Inhibit
FP
-
2860
2861
-
1-333