Siemens CU240B-2 Parameter Manual page 155

p1130[0...n] Ramp-function generator initial rounding-off time / RFG t_start_round
PM230 Access level: 2
Can be changed: U, T
Units group: -
Min
0.000 [s]
Description: Sets the initial rounding-off time for the extended ramp generator. The value applies to ramp-up and ramp-down.
Note: Rounding-off times avoid an abrupt response and prevent damage to the mechanical system.
p1130[0...n] Ramp-function generator initial rounding-off time / RFG t_start_round
PM240 Access level: 2
PM250, PM260
Can be changed: U, T
Units group: -
Min
0.000 [s]
Description: Sets the initial rounding-off time for the extended ramp generator. The value applies to ramp-up and ramp-down.
Note: Rounding-off times avoid an abrupt response and prevent damage to the mechanical system.
p1131[0...n] Ramp-function generator final rounding-off time / RFG t_end_delay
PM230 Access level: 2
Can be changed: U, T
Units group: -
Min
0.000 [s]
Description: Sets the final rounding-off time for the extended ramp generator. The value applies to ramp-up and ramp-down.
Note: Rounding-off times avoid an abrupt response and prevent damage to the mechanical system.
p1131[0...n] Ramp-function generator final rounding-off time / RFG t_end_delay
PM240 Access level: 2
PM250, PM260
Can be changed: U, T
Units group: -
Min
0.000 [s]
Description: Sets the final rounding-off time for the extended ramp generator. The value applies to ramp-up and ramp-down.
Note: Rounding-off times avoid an abrupt response and prevent damage to the mechanical system.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
30.000 [s]
Calculated: -
Scaling: -
Unit selection: -
Max
30.000 [s]
Calculated: -
Scaling: -
Unit selection: -
Max
30.000 [s]
Calculated: -
Scaling: -
Unit selection: -
Max
30.000 [s]
Parameters
List of Parameters
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
2.000 [s]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0.000 [s]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
2.000 [s]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
0.000 [s]
1-155