Siemens CU240B-2 Parameter Manual page 76

Parameters
List of Parameters
p0581 Measuring probe, edge / MT edge
CU240E-2 Access level: 3
CU240E-2 DP
Can be changed: U, T
CU240E-2 DP F
Units group: -
CU240E-2 F
Min
0
Description: Sets the edge to evaluate the measuring probe signal for speed actual value measurement.
0: 0/1 edge
1: 1/0 edge
Dependency: Refer to: p0580
p0582 Measuring probe, pulses per revolution / MT pulses per rev
CU240E-2 Access level: 3
CU240E-2 DP
Can be changed: U, T
CU240E-2 DP F
Units group: -
CU240E-2 F
Min
1
Description: Sets the number of pulses per revolution (e.g. for disks with holes).
p0583 Measuring probe, maximum measuring time / MT t_meas max
CU240E-2 Access level: 3
CU240E-2 DP
Can be changed: U, T
CU240E-2 DP F
Units group: -
CU240E-2 F
Min
0.040 [s]
Description: Sets the maximum measuring time for the measuring probe.
If a new pulse is not received before the maximum measuring time has expired, then the speed actual value in
r0586 is set to zero. This timer is re-started with the next pulse.
Dependency: Refer to: r0586
p0585 Measuring probe gear factor / Probe gear factor
CU240E-2 Access level: 3
CU240E-2 DP
Can be changed: U, T
CU240E-2 DP F
Units group: -
CU240E-2 F
Min
0.00000
Description: Sets the BERO gear factor.
The measured speed is multiplied by the BERO gear factor and is displayed in r0586.
1-76
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
12
Calculated: -
Scaling: -
Unit selection: -
Max
10.000 [s]
Calculated: -
Scaling: -
Unit selection: -
Max
1000.00000
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Data type: Integer16
Data set: -
Factory setting
0
Data type: Unsigned16
Data set: -
Factory setting
1
Data type: FloatingPoint32
Data set: -
Factory setting
10.000 [s]
Data type: FloatingPoint32
Data set: -
Factory setting
1.00000
© Siemens AG 2011 All Rights Reserved