Siemens CU240B-2 Parameter Manual page 167

r1205.0...15 CO/BO: Flying restart, vector control status / FlyRest vector st
Access level: 4
Can be changed: -
Units group: -
Min
-
Description: Displays the status for checking and monitoring flying restart states in the vector control mode.
Bit field: Bit Signal name
00 Speed adaptation circuit record angle
01 Speed adaptation circuit set gain to 0
02 Isd channel enable
03 Speed control switched out
04 Quadrature arm switched in
05 Special transformation active
06 Speed adaptation circuit set I comp to 0
07 Current control on
08 Isd_set = 0 A
09 Frequency held
10 Search in the positive direction
11 Search Started
12 Current impressed
13 Search interrupted
14 Speed adaptation circuit deviation = 0
15 Speed control activated
Note: Re bit 00 ... 09:
Used to control internal sequences during the flying restart.
Depending on the motor type (p0300), the number of active bits differs.
Re bits 10 ... 15:
Are used to monitor the flying restart sequence.
For permanent-magnet synchronous motors (PEM) only bits 10, 11 and 15 are supported.
p1206[0...9] Set the fault number without automatic restart / Fault_No w/o AR
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Selects the faults for which automatic restart should not be effective.
Dependency: The setting is only effective for p1210 = 6, 16.
Refer to: p1210
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
65535
Parameters
List of Parameters
Data type: Unsigned16
Data set: -
Factory setting
-
0 signal
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Data type: Unsigned16
Data set: -
Factory setting
0
FP
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
1-167