Using For Unbalanced Polyphase Output - NF DP060LM Instruction Manual

3. Adjust the value in the [DC Adj] item so that the the DC offset gets close to zero while
observing the output voltage with a DC voltmeter etc.
4. Close the window.
4.15

Using for Unbalanced Polyphase Output

For the polyphase output, you can set the phase voltage and the phase to be unbalanced. The phase
can be set to be unbalanced by 35 degrees to the balanced state.

 Operation procedure
1. Press the [Osc] soft-key and select [6: Phase Mode]. The setting window for the phase mode
opens.
DP060LM/DP120LM/DP180LM

4.15 Using for Unbalanced Polyphase Output

169