Basic Key Operations; Changing The Output Function (Continuous/Sequence/Simulation); Item Selection - NF DP060LM Instruction Manual

3.3

Basic Key Operations

3.3.1 Changing the Output Function
(Continuous/Sequence/Simulation)
To change the Continuous/Sequence/Simulation function, press the MENU key. This operation
displays the root menu shown in the screen below.
Five icons are available in the root menu. The cursor location is informed by the highlighted icon.
The description of the icon at the cursor location is displayed in the box located at the bottom of the
screen.
Move the cursor to the function you want to select by using arrow keys or the jog. Each icon in upper
line represents the Continuous function, Sequence function, and Simulation function from the left.
When you press the ENTER key, the screen for the selected function is displayed. You cannot change
the function in the output on state. However, you can move to the Memory function screen or System
function screen.
3.3.2

Item Selection

You can move the cursor (highlighted icon) by using arrow keys or the jog. However, some items
cannot be selected depending on your system. These items are skipped when moving the cursor. If
you press the ENTER key, the item under the cursor is selected and run. If the item is a menu, the
menu screen, window, or selection box is displayed. If you press the CANCEL key, the menu in the
upper hierarchy is displayed without selection or execution of that item.
DP060LM/DP120LM/DP180LM
3.3 Basic Key Operations
35