NF DP060LM Instruction Manual page 60

3. Basic Operation
3. Move the cursor to the desired output phase configuration and press the ENTER key.
4. After the screen below is displayed, turn off the power and change the wiring (output cable and
sensing cable).
5. Cycle the power of the product.
CAUTION
 In the single-phase two-wire (1P2W) output, do not connect anything to the polyphase output
terminal.
 In the single-phase three-wire (1P3W) output and the three-phase four-wire (3P4W) output, do
not connect anything to the single-phase output terminal.
 In the single-phase three-wire (1P3W) output, do not connect anything to the L3 terminal.
WARNING
 Be sure to turn off the power switch of this product and switch off the breaker at the distribution
board, before touching the output terminal. Otherwise, an electric shock might occur.
42 PROGRAMMABLE AC POWER SOURCE