Output Phase Configuration; Output Function; Output Range - NF DP060LM Instruction Manual

11. Specifications
Specifications are valid under the following settings and conditions and after a warm-up period of
30 minutes at least, unless otherwise noted.
Load
Signal source
Output voltage waveform
Remote sensing
AGC/Autocal
Current Limiter
[set] indicates a setting value, and [rdg] indicates a read value.
The description noted with "/" indicates that the specification changes by the output range, such as
"100 V range specification/200 V range specification."
The input voltage is noted as line voltage in three-phase four-wire input, unless otherwise noted.
A value with the accuracy is the guaranteed value of the specification. However, an accuracy noted
as reference value shows the supplemental data for reference when the product is used, and is not
under the guarantee. A value without the accuracy is the nominal value or representative value
(shown as typ.).
The product corresponds to Clause 2 (8) Frequency converter, Appendix 1 of Export Trade Control
Ordinance. The permission for exportation of the Japanese Administration is necessary for export
outside Japan.
11.1

Output phase Configuration

Output phase
Configuration
11.2

Output Function

Output Function
11.3

Output Range

Output Range
248
Resistance load of power factor 1
INT (internal signal source)
Sine wave
Off
Off
Factory default setting
Single-phase output
Single-phase two-wire
Single-phase output
Continuous, Sequence, Simulation
Single-phase output
100 V range, 200 V range
Polyphase output
Single-phase two-wire,
Three-phase four-wire (Y-connection)
Polyphase output
Polyphase output
PROGRAMMABLE AC POWER SOURCE