NF DP060LM Instruction Manual page 69

2. Select the [ACV] item and then enter a numeric value. For how to enter values, see 3.3.5.
  Operation procedures for setting the line voltage
1. Press the [Osc] soft-key and select [5:Target Phs]  [5:All Line]. Or perform the Shortcut
operation
area (see 5.1) is
2. Select the [ACV] item and then enter a numeric value. For how to enter values, see 3.3.5.
-------- Notes ------------------------------------------------------------------------------------------------------------
 The line voltage can be set only for the sine wave in the balanced mode.
-----------------------------------------------------------------------------------------------------------------------------
DP060LM/DP120LM/DP180LM
+ to switch to [All Line]. Check that the icon in the output display
(single-phase three-wire system)/
3.4 Using the Continuous Function
(three-phase system).
51