NF DP060LM Instruction Manual page 120

4. Advanced Operation
2. When pushing [Compile] soft key in the Sequence Edit View, moved to Sequence Control View.
You can check measurements in step No.0. When pushing [Start] soft-key, the sequence is started.
3. Remote Sensing function and Autocal function can be enabled in step No.0 in the Sequence Edit
View and the Sequence Control View.
■Turning on the Remote Sensing Function
1. Open the AGC/Autocal set window by shortcut operation:
2. Use the [Rmt Sense] item to set the Remote sensing function to on or off.
3. Close the window.
Sequence Edit View
■Turning on the Autocal Function
1. Turn on the output.
2. Open the AGC/Autocal set window by shortcut operation:
3. Use the [Rmt Sense] item to set the Remote sensing function to on or off if necessary.
4. Use the [Auto Cal] item to turn on the Autocal function. In case within operating range of Autocal
when [ON] is selected here, the calibration factor of the Autocal function is calculated, and the
calibration is started.
5. Close the window.
102
.
＋
Sequence Control View
.
＋
PROGRAMMABLE AC POWER SOURCE