Restoring To The Factory Default Setting (Reset); Table 4-17 Setting Items To Be Reset - NF DP060LM Instruction Manual

4. Advanced Operation
3. In the [Contrast] item, set the contrast value.
4. Close the window.
4.27

Restoring to the Factory Default Setting (Reset)

If you reset this product, the setting items marked with  in Table 4-17 are restored to the factory
default settings. Ensure that you reset this product in the output off state.
Setting Item
Output on/off
Output range
AC/DC mode
Signal source
External synchronization signal (LINE
or EXT)
AC voltage setting
Frequency
Output waveform
Output on phase
Output off phase
Phase voltage/Line voltage setting
selection
Line voltage setting
Phase angle setting
Balanced/Unbalanced
DC voltage setting
Current limiter
Setting range limit
External input gain
Phase to be measured
Output function
194

Table 4-17 Setting Items to be Reset

Reset
×



















Factory default setting
Off
100 V range
AC mode
INT
LINE
0 V
50 Hz
Sine wave
0.0 deg
Enabled, 0.0 deg
Phase voltage
0 V
Single-phase three-wire: 180 deg
Three-phase: 120, 240 deg
Balanced
0 V
See 11.14
See 11.15
0
L1
Continuous
PROGRAMMABLE AC POWER SOURCE