Cautions During Moving And Transportation - NF DP060LM Instruction Manual

2. Preparation before Use
2.3

Cautions during Moving and Transportation

Follow the instructions below when moving or transporting this product.
  Remove all wirings connected to this product.
WARNING
 Power is still input after turning off the power switch. Be sure to switch off the breaker at the
distribution board before removing the wiring. Otherwise, an electric shock might occur.
  Check before movement and transportation
 Check the weight before moving the product (Table 2-3).
  Moving with casters
The casters attached to this product are intended for use to move the product on a horizontal surface.
To move the product on a sloped or uneven surface, a licensed personnel should move it by operating
a lifting machine or crane instead of the casters.
 As this product is heavy, whenever it is moved, at least two people are required to move it.
 Move the Adjuster Foot up enough from the floor by using an open-end wrench
(DP060LM/DP120LM: 19 mm width, DP180LM: 30 mm width). You can move the Adjuster
Foot up by turning it counterclockwise as viewed from above.
WARNING
 Do not use the casters to move this product on a sloped surface. This product may move
automatically due to its own weight, and cause death or severe injury of people around.
 Do not use the casters to move this product on an uneven or irregular surface. This product may
fall down, and cause death or severe injury of people around.
12 PROGRAMMABLE AC POWER SOURCE