Output Cable Connection; Figure 2-5 Terminal Block Layout - NF DP060LM Instruction Manual

2.5

Output Cable Connection

  Before connecting, check the followings.
WARNING
 Be sure to turn off the power switch of this product and switch off the breaker at the distribution
board, before touching the output terminal. Otherwise, an electric shock might occur.

  About output terminal
The output terminal is divided into two terminals, polyphase output terminal and single-phase output
terminal as shown in Figure 2-5. Single-phase output terminal is used in single-phase two-wire
output (1P2W), Polyphase output terminal is used in single-phase three-wire output (1P3W) and
three-phase four-wire (3P4W). Table 2-6 shows the screw sizes of the output terminals of each
model.
Polyphase output
panel
Power input and
output panel
Power input
terminal
Power input terminal
Powe input
panel
Power input terminal of this figure is for power input three-phase three-wire.
DP060LM/DP120LM/DP180LM
Sensing input terminal
DP060LM / DP120LM
Sensing input terminal
DP180LM

Figure 2-5 Terminal Block Layout

2.5 Output Cable Connection

Polyphase output
terminal
Output panel
Polyphase output
terminal
Used in
1P3W, 3P4W
output.
Sigle-phase output
terminal
Used in
1P2W output.
Single-phase output
terminal
17