3.4
Using the Continuous Function
3.4.1
Setting output phase configuration
You can switch output phase configuration.
When switching output phase configuration, the internal memory No.1 settings are loaded at the
output phase configuration after switching. (See 4.8.1)
Operation procedures
1. Press the MENU key to move to the root menu in the Continuous function, and then select
[System]. The system setting window opens.
-------- Notes ------------------------------------------------------------------------------------------------------------
Move to the root menu in the Continuous function. The output phase configuration cannot be
changed in the Sequence or Simulation function.
Turn off the output before moving to the root menu. You cannot move to the root menu in the
output on state.
-----------------------------------------------------------------------------------------------------------------------------
2. Press the [OutPhsMd] soft-key, and open the setting window of output phase configuration.
DP060LM/DP120LM/DP180LM
3.4 Using the Continuous Function
41