Change Output Parameter During Output On; Figure 4-10 Sequence Control View (Output On State/Sequence Stopped) - NF DP060LM Instruction Manual

  Sequence Control View (output on state/sequence stopped)
Icon

Figure 4-10 Sequence Control View (Output On State/Sequence Stopped)

4.2.13

Change Output Parameter during Output ON

Frequency and voltage of step No.0 can be changed on Sequence Edit View and it can be used like
Continuous output function. Remote Sensing function and Autocal function can be enabled. See 4.11
and 4.13 for detail of Remote Sensing function and Autocal function.
1. Select frequency and voltage, input them in the Sequence Edit View step No.0 and turn ON output,
setting voltage will be output. Changing setting value, it will be applied soon.
DP060LM/DP120LM/DP180LM
Frequency setting
4.2 Using Sequence Function
Measured value to be
displayed
Output setting of
step No.0
Voltage setting
101