About Installation Environment; Figure 2-1 How To Use The Adjuster Foot; Table 2-2 Heat Value; Table 2-3 Mass - NF DP060LM Instruction Manual

2.2

About Installation Environment

To use safely and maintain the reliability, take the followings into consideration:
  Install the product where the exhaust heat will not damage surroundings.
 This product performs forced air cooling using a fan. Keep the front and rear, on which the air
inlet and outlet are located, away from the wall at least 50 cm to secure air circulation.
 This product exhausts the heat from the air outlet on the rear. Do not place heat-sensitive objects
around the outlet.
 If you install the product in a closed narrow room, air conditioning equipment is required. The
heat value of this product is shown in Table 2-2.
Model
DP060LM
DP120LM
DP180LM
Note: Estimate at power input single-phase 200 V or three-phase three-wire 200 V or
three-phase four-wire 380 V (phase voltage 220 V), rated output.
  Install the product on a sturdy place.
 The floor needs to have enough strength to support the weight of this product. The mass of this
product is shown in Table 2-3.
 Do not install this product on a sloped surface. The Adjuster Foot is only for temporary fixing,
and cannot support the unit's own weight. You also must not lean on this product or use it as a
support. How to use the Adjuster Foot is shown in Figure 2-1.
Up Down
Up Down
 There are screw taps for anchor brackets on this product.
DP060LM/DP120LM/DP180LM

Table 2-2 Heat Value

Rated output
6 kVA
12 kVA
18 kVA

Table 2-3 Mass

Model
DP060LM
DP120LM
DP180LM
The Adjuster Foot can be moved up by rotating it counterclockwise and
moved down by rotating it clockwise as viewed from above.
Use an open-end wrench.
(DP060LM / DP120LM: 19mm width, DP180LM:30mm width)

Figure 2-1 How to Use the Adjuster Foot

2.2 About Installation Environment

Heat value
1.8 kW 1550 kcal/h
3.6 kW 3100 kcal/h
5.4 kW 4650 kcal/h
Mass
125 kg approx.
200 kg approx.
350 kg approx.
9