NF DP060LM Instruction Manual page 22

1. Outline
  Control Software included by default
You can perform the following operations by using Control Software included in the attached
CD-ROM:
 Operations same as those performed on the control panel
 Editing/transferring/exporting the arbitrary waveform data*
 Data logging (importing the measured values)
 Editing/transferring/exporting*/performing Sequence
 Editing/transferring/exporting*/performing Simulation
*Exporting the data to USB memory allows the data to be set to DP060LM/DP120LM/DP180LM.
  USB memory support (supported format type: FAT32)
You can write/read the following data to/from a commercial USB memory stick:
 Basic setting
 Sequence
 Simulation
 Arbitrary waveform
  Restriction of power usage during operation
The efficiency is improved by about 27 % compared to the linear amplifier method by adopting the
switching amplifier method. When the power output is low, the internal loss can be lowered by
reducing the number of power units being powered on.
  Selecting specification when ordering
 Power Input
Single-phase input* (1P2W) /three-phase three-wire input (3P3W)
/three-phase four-wire input (3P4W)
* Single-phase input can be selected for the model of which the output capacity is 12 kVA or less.
 Communication Interface
GPIB or LAN (LXI 1.4)
  Options (partial)
 Remote Controller
A remote controller with the numeric keypad, jog, and shuttle.
 Power Cable
Cables for the power input.
4 PROGRAMMABLE AC POWER SOURCE