3. While checking the DC offset of the output voltage, adjust the value in the [DC Adj] item so
that the DC offset gets close to zero.
4. Close the window.
4.15
Using for Unbalanced Polyphase Output
For the polyphase model and polyphase system, you can set the phase voltage and the phase to be
unbalanced. The phase can be set to be unbalanced by ±35 degrees to the balanced state.
Operation procedure
1. Press the [Osc] soft-key and select [6: Phase Mode]. The setting window for the phase mode
opens.
DP Series
4.15 Using for Unbalanced Polyphase Output
169