Figure 2-6 How To Attach Resin-Molded Cover In Single-Phase Output - NF DP060LM Instruction Manual

WARNING
 Do not use this product when the resin-molded terminal cover is removed. Otherwise, an electric
shock might occur.
 Use enough thick cables to prevent touching live conductive parts after attaching the
resin-molded terminal cover. If a thin cable is connected, fingers may enter the gap between the
resin-molded terminal cover and the cable, resulting in electric shock, therefore attach some
additional guards.
 When no load is connected, attach the resin-molded terminal cover so that the cutout of the
cover faces upside.
 Do not remove the polyphase output terminal cover.
 Attach the polyphase output terminal cover so that the cutout of the cover faces upside.
DP060LM
Polyphase output panel cover
Power input and output
panel cover
Power cable
Sensing input cable
Single-phase
output cable

Figure 2-6 How to Attach Resin-molded Cover in Single-phase Output

DP060LM/DP120LM/DP180LM
DP120LM
Polyphase output panel cover
cover
Single-phase output cover
Power input and output
Bent part at the back side
panel cover
Power cable
Sensing input cable
Single-phase
output cable
2.5 Output Cable Connection
DP180LM
Output panel cover
Sensing input cable
Single-phase
output cable
19