Table of Contents
Advertisement
3.2.2
Power On
Press "On" side of the power switch.
3.2.3
Screen Display and Operations at Starting Up
When you power on the cabinet, all LEDs in the control panel illuminate. The LEDs are lighted off
after a while and the following contents are displayed in the order below.
1. The "NF" logo mark is displayed for a few seconds or more than 10 seconds. The length for
which this logo is displayed depends on your model and system.
2. The self check is performed and the result is displayed. If any problem is detected the startup
process halts in the self check screen shown in the figure below. Check the self check result
and press the ENTER key to resume the startup process.
3. Depending on the output function selection setting at power-on, the Continuous function
screen, Sequence function screen, or Simulation function screen is displayed. For detailed
information about the output function selection at power-on setting, see 4.2.10 and 4.3.10.
4. If the output function selection is set to the Continuous function and the output-on at
power-on setting is on, the output is turned on after the confirmation message to inform that
the output is automatically turned on is displayed for about 10 seconds. If you press the
ENTER key while this message is displayed, you can cancel the setting of automatic
output-on. For detailed information about the output-on at power-on setting, see 4.22.
DP060LM/DP120LM/DP180LM
POWER
OFF
ON
3.2 Power On/Off
33
Advertisement
Table of Contents
