NF DP060LM Instruction Manual page 42

2. Preparation before Use
4. Set the output phase configuration to the one that checks operation.
Refer to 3.4.1 about setting output phase configuration.
5. Except when you purchased a new product, refer to 4.27 Restoring to the Factory Default
Setting (Reset) to initialize the product to factory defaults. The product will be reset, and display
the Continuous screen automatically.
6. When you purchased a new product, the product will start and then display the Continuous screen
automatically.
7. Check that the measured values of 100 V range, AC-INT, V, and I are displayed in rms, and that
the AC voltage (ACV) is set to 0 V.
24 PROGRAMMABLE AC POWER SOURCE